Nails Video, Дизайн Ногтей, Наращивание Ногтей

acrylic nail art, gel nail design, материалы для ногтей, рисунки ногтей, роспись ногтей...

Рубрики

Detachment. Problems and their solutions. Capacity nail acrylic. nail classes. Acrylic nails.

07.04.2009

Once more on detachment or air pocket ".

Perhaps it is the most common problem in the master nail service! Spalling of material, or the appearance of "air pockets" (even the so-called), often occurs due to a number of errors that allowed the wizard in the process of modeling nails. The reasons for a lot of detachment. Let's look at all the mistakes in building the nail acrylic.
To reiterate:
Violations of technology, simulation technology, including the preparation of natural nails - these are the causes of exfoliation material. All of these errors can occur during the preparation of nail to build, and later - in the simulation.
BUGS:
1. One of the most common errors: Preparing to nail capacity, she is careful removal and disposal pterigiya minimum pollution and the fat layer with a nail.
2. Do not use rough sawing obrazivnosti: excessive or flagrant opilivanie the thickness of the natural nail plate weakens its adhesive properties, that would mean that the material will have a much smaller degree of adhesion. Most often, the natural nail perepilivayut and often in the transverse direction, and this leads to consequences: separation, thinning of nails, nail bed pain.
3. An important factor is the degree of natural skin moisturizing hand: if it is wet from nature, the spalling of material usually occurs before opilivaniya nails.
4. Processing the natural nail plate sawing, it is necessary to give particular emphasis to the area of the side rollers: in addition, that the zone of greatest contamination nail plate, it is still hard to reach places.
5. Ignoring antiseptic, degreasing and dewatering units.
6. Excessive use of primer is often alters the structure of natural nails and cause exfoliation material.
7. Minute speck orogovevshey skin, go to the nail, in the future lead to detachment of material.
8. Violation ratio of powder and elimination: if the acrylic ball is too dry, it will be impossible to squeeze; too wet ball zatechet in cuticle or solidifies before the end, and when opilivanii material will creep under the sawing, resulting in exfoliation material.
9. Layout of a thick layer near the inner lining quickly leads to the "air pockets".
10. Nails and exfoliate with blunt sawing when opilivaem already naroschennye nails: the thickness is not removed, the material is heated.
11. When working with shapes, angles in a stressful area of poorly pressed: the spread of the thick material in the vicinity of rollers and formed a gull, in the end - detachment.
12. Creating a form with opile, it is important vymeryat C-curves and arches, with a properly Apex (highest point). The slightest thickening causing exfoliation material, especially in the area of the inner lining, the fact is that it changes the correct line of the longitudinal arches and S-bends. Even if you're up to the moment opilivaniya not allowed a single mistake, mikroapeks lead to detachment of material, as well as from the standpoint of physics, thickening - this is an additional source of improper distribution of the surface tension of nail (mikroapeks).
13. During the walk on the correct nails. Standard delay between the correction of 2-3 weeks. Because at the time of correction of the natural nail grow and shifts the stress zone ahead, that violates other aspects of the proper construction of an artificial surface. When otrostanii natural nails under artificial spalling evident in the area of free edges. This is due to the fact that the natural nail, giving with one hand covered with acrylic, on the other - has no basis in the form of nail bed. Otrosshy edge nail begins intensively to give water, curling and exfoliate from artificial material. Therefore, correction must be made on time, or nails naroschennye shoot and make new ones.
14. If the correction you find "air pockets" before vykladyvaniem material they need to be carefully cut down. By removing the peeling sawing, it is necessary to work very carefully, without affecting the natural nail.
15. The brush should always be washed and not dusty.
16. Cold hands - the same reason otsloek. Keep an eye on the temperature of the room, but to build sogreyte first hand.

WITH PLEASURE AND FOR-YOU MORE CUSTOMERS!

Ярлыки: English

posted by Blogger @ 20:22

0 Comments:

Отправить комментарий

<< Home

10 Новых записей

Архив

Ссылки